Introduction
A week ago I finished my audio cooler. Although I was happy with the result improvements could be made (as is always the case). Most important I didn’t particularly like the console on the side of the coolers lid. This was a 3d printed part of PLA that I glued to cooler with a superglue. This was far from ideal because of the space left between the printed console and the cooler . Another improvement could be made by the way that the speaker was fitted to the lid of the cooler. The speaker was directly attached to cooler with four screws again leaving some space between the two. I already had some FilaFlex filament but hadn’t used it yet. Because of the elastic and flexible properties of Filaflex I figured that I could both fix the issues with the console and the speaker.

You must be logged in to post a comment.